{"id":35,"date":"2014-11-12T01:05:39","date_gmt":"2014-11-12T06:05:39","guid":{"rendered":"http:\/\/braarc.net\/?page_id=35"},"modified":"2026-03-08T21:58:51","modified_gmt":"2026-03-09T01:58:51","slug":"event-registration","status":"publish","type":"page","link":"https:\/\/braarc.net\/?page_id=35","title":{"rendered":"Repeaters"},"content":{"rendered":"

BRAARC Supported Repeaters<\/strong><\/h1>\n

 <\/p>\n

\"WDEE<\/a>

WDEE Tower<\/p><\/div>\n

146.740 MHz – offset (Status – Operational)<\/h2>\n
\n
\n

The BRAARC 2 meter repeater is located in NE Newaygo County. It transmits on 146.74 with a – offset. The BRAARC repeater shares a tower with WDEE and the Independent Repeater Associations (IRA) Big Rapids 2 meter link repeater. The IRA operates this linked repeater as part of the IRA link system which operates on 145.29 MHz.<\/p>\n

The repeater uses two DB224 4 bay Dipole Array antenna at 150 feet for receiving and 120 feet for transmitting. The system uses a CAT1000 controller and Yeasu DR-1 in FM mode: 20 watts. The repeater was relocated to a new site December 2018.\u00a0 The old site DB224 transmit antenna was located at 180 feet and the Hustler G7 receive antenna was located at 120 feet.\u00a0 The former MICOR Transmitter\/Receiver was retired in 2016. The repeater auto patch capability was discontinued in 2018.\u00a0 Additional repeater function information is available in the Repeater Operations guide.<\/p>\n

The effective range is 30 miles but conditions may allow for longer transmitting distances.<\/p>\n<\/div>\n<\/div>\n

 <\/p>\n

\n
\n
\"FSU<\/a>

FSU Cramer Hall<\/p><\/div>\n

443.900 MHz + offset (Status – Operational)<\/h2>\n

The 440 repeater is located on top of Cramer Hall on the campus of Ferris State University. It transmits on 443.9 MHz with a +5 offset.<\/p>\n

The repeater uses a Diamond X-300NA dual band antenna mounted at 110 feet above the ground.\u00a0 This antenna project included replacing the 50 feet of coax with DX Engineering 400Max Low Loss Coax.\u00a0 The coax is secured to the building using stackable snap-in clamps with plastic inserts.\u00a0 All connectors are “N” connectors and are weather sealed.\u00a0 The Hustler Spirit, Fixed Station antenna by New-Tronics Ltd. was removed from service in July 2019 due to a high SWR condition. This repeater is controlled by a CAT1000 controller. The RF section is a Yeasu DR-1 in FM mode: 20 watts. The former Motorola Radius GM300 radios were retired in place in 2016. The repeater auto patch capabilities were discontinued in 2026. Additional functions are available in the Repeater Operations guide.\u00a0 The range of the repeater is +\/-25 miles.<\/p>\n

\"Diamond<\/a>

Diamond X-300NA<\/p><\/div>\n<\/div>\n<\/div>\n

Echolink 389477 – 443.900 MHz + offset (Status – Operational)<\/h2>\n
\n
\n

The Echolink (www.echolink.org<\/a>) linking system is available on the 440 repeater.\u00a0 You are able to connect to remote nodes around the world and they are able to connect to the 440 repeater.\u00a0 Node Number:<\/span><\/span>389477 or K8FSU-R<\/span><\/p>\n

The on air commands are as follows:
\nConnect:<\/span> DTMF C then the node number. (four to six digits)
\nDisconnect:<\/span> DTMF #\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0Disconnect All:<\/span> ##.
\nLink Down:<\/span> A123\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0\u00a0Link Up:<\/span> B123<\/span><\/p>\n

<\/h2>\n

52.860 MHz – Offset (Status – Off the air)<\/h2>\n

The 6 meter repeater is permanently of the air.\u00a0 Do to lack of support and use the resources used to support this repeater were redirected to the 440 and 2M repeaters.\u00a0 Thank you to those who supported this repeater throughout the years.\u00a0 It transmitted on 52.860 MHz with a -.5 offset.\u00a0 The repeater is not being relocated at this time.\u00a0 Donations are being accepted for the installation of a Peet Brothers Ultimeter Weather Station<\/a>. If enough donations are received, the Club will review adding the weather station to the 440 or 2M repeater.<\/p>\n

This Repeater used a GE Executive II Tranceiver and a CAT200B Repeater Controller.<\/p>\n

DTMF Keypad Test
\nKey-up, and enter [375], the DTMF keypad access code followed by the keypad numbers and letters to be tested.\u00a0 The entries can be in any order.\u00a0 Un-key, and the voice will read-back all numbers and letters that were decoded including\u00a0 the “star” and “pound”.<\/p>\n

Communication Nets<\/strong><\/h2>\n